Snowflake Arch Reinforcement Plates

There are a few points on the snowflake arch that could crease if the prop is picked up, with pixels, in a manner where the weight of pixels could fold the prop a bit.

At Christmas Expo 2023 someone requested a simple STL 3D print file to be able to print themselves and attach.  

That file can be found by clicking here

There are no copyright/usage requirements.  You may print or have friends/family print.

You will need to print 4 of these (they are all the same).  You will also need to drill the prop.  The prop is not predrilled for this as it isn't necessary, just a useful addition to strengthen this point.

Here is the location where these blocks would be located: