StarFlake - 7ft tall, 7.4ft wide, 500 pixels, easy break down!

This unique "Star Flake" is named due to it's snowflake arms arranged to make a large star in the middle!

This prop, overall, is 7ft tall and 7.4ft wide.  Each piece is identical and requires 100 pixels.  Overall the prop takes 500 pixels (5 pieces).  This design is meant to break down easily with a center support (1, shown as red in photo) that should have pixels able to slide in/out without removing.  Additional support brackets (6, one shown in red in photo) can be used (but would require 2 pixels to be removed) where the star arms connect.  Wiring is identical in each piece with both pixel 1 and 100 in close proximity to connect to the next arm (no extensions needed).  4" wiring pixels required.

Designed to fit 12mm pixels with 4" spacing.

A 3d printed kit to utilize 1/2" EMT is available as an additional add on.  This kit places a support at each end of the flake, has a center section to take the EMT from each section.  One of the pipes is extended past the center to an additional support (which sits on top of the center support coro bracket), which that pipe supports the rest.  Each piece on the end has an open end design to allow the EMT to pass through for additional mounting options.  The EMT pipe is placed above wiring for even 4" spaced pixels.  Note - these are 3D printed items and, as such, may not be perfect.  These are made of strong, UV resistant ASA filament.  If more than 1 is ordered the lead time may increase as the print time is a full day for 1 kit.